VAG COM 908
VCDS 908/VAG COM908
VCDS V908, Vag com908, VAG908
VCDS 908,VAG COM908
Supports Measuring Values, Output Tests, and Adaptations on control modules using the new UDS/ODX/ASAM protocol.
Adds new UDS addresses and updated ODX data for 2010 models.
Includes support for TP1.6 protocol which is required for the 6J
The Select Control Module screen now shows "Installed Modules" rather than "Common Modules" if the car being worked on is new enough to have a proper CAN Gateway.
Modified SRI Screen to show more info and force user to select a job before proceeding.
Adds drop-box function selection in Basic Settings and Adaptation.
Reads Mileage stored in many EDC16 ECUs.
New CODES file, now with over 13, 000 fault code and measuring value texts.
New USB drivers for enhanced PC compatibility and stability.
New firmware for HEX interfaces required for compatibility with 6J
Updated Label files; better documentation for new and existing models.
- what is the difference between tacho pro 2008 and digiprog3
2016-07-14 - New tool OBDSTAR PRO3 for immo and odometer correction
2016-07-13 - the software of HDD for vas5054 can not be copied
2016-07-12 - vas5054 full chip with OKI and bluetooth
2016-07-11 - hand baby/Cbay open G function
2016-07-10 - the active of FVDI2
2016-07-07 - Launch X431 GDS 12-24V English Diesel Diagnostic Configuration Heavy Duty
2016-07-06 - X100 PAD original key programmer of xtool
2016-07-05 - the code of digiprog3 odometer correction
2016-07-04 - New MB SD Connect Compact 4 with UDS diagnose protocol
2016-07-03
Email: sale@car2diag.com
MSN: sale@car2diag.com
SKYPE: autocables
SKYPE: car2diag03