Power Supply for BMW OPS OPPS Programming
Power Supply for BMW OPS OPPS Programming
THIS POWER SUPPLY IS SPECIALLY FOR BMW OPS PROGRAMMING.
USUALLY FOR PROFESSIONAL PROGRAMMING FOR NEW BMW AND MAINTAINING COSTANT VOLTAGE AND CURRENT DURING VEHICLE ASSEMBLEY TO PROGRAMMING
During programming power levels must be maintained in a narrow range to minimize the chance of damaging controllers. It must be adjusted voltage between 12.8 till 13.5 Volt before connect power cable to car battery. There is a LCD Monitor to show the statistics .
It is no need to run a car to supply for permanent and stable voltage.
It can adjust the AC and DC .It is very strong and stablization.
Recommended by almost all manufacturers from BMW and Mercedes Benz to Volvo, Porsche, Volkswagen, Audi, Mann and many others.
Not a Battery Chargers , TWO MODEL YOU CAN SELECT: A:0-14V, 0-60A; B: 0-14V, 0-100A
- what is the difference between tacho pro 2008 and digiprog3
2016-07-14 - New tool OBDSTAR PRO3 for immo and odometer correction
2016-07-13 - the software of HDD for vas5054 can not be copied
2016-07-12 - vas5054 full chip with OKI and bluetooth
2016-07-11 - hand baby/Cbay open G function
2016-07-10 - the active of FVDI2
2016-07-07 - Launch X431 GDS 12-24V English Diesel Diagnostic Configuration Heavy Duty
2016-07-06 - X100 PAD original key programmer of xtool
2016-07-05 - the code of digiprog3 odometer correction
2016-07-04 - New MB SD Connect Compact 4 with UDS diagnose protocol
2016-07-03
Email: sale@car2diag.com
MSN: sale@car2diag.com
SKYPE: autocables
SKYPE: car2diag03