ETL M35080V6 ERASER/Programmer
ETL M35080V6 ERASER/Programmer
M35080V6 Programmer, M35080V6 ERASER,ETL M35080V6 ERASER/Programmer
Easy to use Windows 98/2000/XP software:
Read, Program, Erase Incremental Registers\EEPROM
Erase time to Delivery State* 1-3 seconds
Erase time to Delivery State for M35080V6 1-10 minutes
Supported all clock rates 2.5, 5.0 and 6 MHz IC's.
In-circuit/On-board EEPROM programming
On-board EEPROM programming for M35080V6
Self-Check capabilities
Onboard processor ATmega16 allow to Firmware Update to new versions
4 adaptors for SO8 device
Additional items you'll need to use this tool:
1) Host: A 32 Bit x86 based or Pentium PC with a free Com1-8 communication port.
2) Power supply: An 12 Volt / 500 mA
NOTE:
For more details see M35080V6 EEPROM ERASER/PROGRAMMER
- what is the difference between tacho pro 2008 and digiprog3
2016-07-14 - New tool OBDSTAR PRO3 for immo and odometer correction
2016-07-13 - the software of HDD for vas5054 can not be copied
2016-07-12 - vas5054 full chip with OKI and bluetooth
2016-07-11 - hand baby/Cbay open G function
2016-07-10 - the active of FVDI2
2016-07-07 - Launch X431 GDS 12-24V English Diesel Diagnostic Configuration Heavy Duty
2016-07-06 - X100 PAD original key programmer of xtool
2016-07-05 - the code of digiprog3 odometer correction
2016-07-04 - New MB SD Connect Compact 4 with UDS diagnose protocol
2016-07-03
Email: sale@car2diag.com
MSN: sale@car2diag.com
SKYPE: autocables
SKYPE: car2diag03