Bmw ops
BMW OPS
BMW OPS Pro can be used with any laptops or PC, just connect the External Hard Drive with computer.Designed for encoding, individualising and programming ( CIP) via the Software Service Station (SSS) and envisaged for use as part of the BMW diagnostic system (DIS) from DISPlus and Group Tester One (GT1).Intended for testing and programming tasks from the E65 series, taking the place of the diagnostic head.
OPS is mainly used for diagnosis and programming BMW vehicles after E65 series .
OPS unit with DIS software is used for diagnosis, which is carried out via OBD-II
socket .OPS unit with SSS software is used for programming, which is carried
out via OBD-II socket and MOST socket.
On vehicle models from the E65 on, BMW is for the first time using fibre-optic cables as standard for communication between control units.
The optical buses are notable for their high data transmission rate and they are not susceptible to electromagnetic interference. The optical buses in question are the MOST bus, primarily used for in-car entertainment electronics, and the byteflight bus, which serves predominantly safety-critical functions.
OPPS has been designed for encoding, individualising and programming ( CIP) via the Software Service Station (SSS) and envisaged for use as part of the BMW diagnostic system (DIS) from DISPlus and Group Tester One (GT1). It is intended for testing and programming tasks from the E65 series, taking the place of the diagnostic head.
OPS is intended for rapid programming of control units.
When operated at the SSS, no diagnostic or technical measuring pro-cedures are possible, as no measuring technology is incorporated; in this instance, OPPS / OPS is used predominantly for programming control units (flashing). Communication with the vehicle can be performed both via the MOST and via the OBD interface. The OBD interface is required for the power supply to the OPPS / OPS and has communication properties via which the vehicle can be identified and the data to be programmed can be determined. From CIP version 7.0, it is possible to delete fault code memories via OPPS / OPS.
Package including:
Standard Configuration:
1. OPS multiplexer
2. OBD-II diagnostic cable
3. LAN cable(RJ45 / ODU plug)
4. OPS MOST cable
5. DIS V57, SSS V3280 G Hard drive
Optional:
7. IBM T30 with two Hard disc (DIS SSS)
8. ToolBox(Optional)
- what is the difference between tacho pro 2008 and digiprog3
2016-07-14 - New tool OBDSTAR PRO3 for immo and odometer correction
2016-07-13 - the software of HDD for vas5054 can not be copied
2016-07-12 - vas5054 full chip with OKI and bluetooth
2016-07-11 - hand baby/Cbay open G function
2016-07-10 - the active of FVDI2
2016-07-07 - Launch X431 GDS 12-24V English Diesel Diagnostic Configuration Heavy Duty
2016-07-06 - X100 PAD original key programmer of xtool
2016-07-05 - the code of digiprog3 odometer correction
2016-07-04 - New MB SD Connect Compact 4 with UDS diagnose protocol
2016-07-03
Email: sale@car2diag.com
MSN: sale@car2diag.com
SKYPE: autocables
SKYPE: car2diag03